Summer storms and your UPS
(Uninterruptible Power Supply)
devices and surge protectors
by Michael Appollo, CTO, NST
We hope you have
have successfully weathered the summer storms. Now is a good
time to check your UPS (Uninterruptible Power Supply)
devices and surge protectors because there is a good chance
they have taken some voltage hits and suffered power outages.
Larger UPS
devices, otherwise known as Battery Backups, may have power
indicators that tell you how much battery capacity is left.
Smaller devices may not have such indicators. If they are
connected to a computer, chances are good they came with
some software that gathers that information. Opening the
software can give you some general idea of the overall
health of your UPS. Either way, you can't always believe the
lights and software; the best test of a UPS is to
periodically unplug it fromt the wall and seeing how long
the items plugged in still run. Most UPS devices will beep
until power is restored, so this is normal behavior. If your
computer is plugged in to one of these, please make sure
that all applications are closed before trying this! If you
want to test the capacity of the UPS, you can leave the unit
unplugged and time how long it is until your connected
devices begin to power off. If the time is short, you can
purchase a newer, larger device, or plug fewer items into
the UPS; the more devices a UPS has to keep powered during
an outage, the shorter the duration it will last. One
important note: many UPS devices have outlets that are not
protected by the battery, and in the event of a power
outage, anything plugged into one of those outlets will
simply shut off. We have seem many instances where a client
has plugged devices into the wrong outlet. I was a client
earlier this week where they unplugged a router and computer
to move a desk. When they plugged everything in again, the
router and cable modem were in surge-only protected outlets.
Please read the UPS labeling carefully to ensure you are
using the correct outlets.
Surge
protectors fail over time as well, especially as they are
subjected to the constant fluctuation in voltage. Most
modern surge protectors have a light when power is running
through it. If the light is steady, the surge protection is
still functioning. If the light is flickering, you have
minimal protection and should replace the surge protector.
If, when power is still running through the surge protector,
the light is off, then you have nothing more than an
extension cord and anything plugged in is not protected at
all, so these should be replaced immediately.